General Instructions - JANE quartz Instructions

GENERAL INSTRUCTIONS

In order to correctly protect the child and ensure he is comfortable and secure in the vehicle it
is necessary to follow the instructions below:
• Your QUARTZ car safety seat has been designed to be installed on the back or front seat
of your vehicle, provided the car is fitted with 3-point seat belts. However, we recommend
that whenever possible you install the safety seat on the back seat of the car, as this position
provides maximum safety.
• It is only suitable for vehicles that are fitted with automatic 3-point seat belts, that are ap-
proved under Standard ECE-16 or other equivalent standards. DO NOT use the safety seat
with a 2-point seat belt as this would be very dangerous in the event of sharp braking or an
accident.
• In some vehicles the buckle strap of the seat belt can be positioned quite far forwards and
may come into contact with the edge of the booster seat, which makes the position unsafe.
In this case, try moving the vehicle seat forwards or installing the safety seat on another seat
in the car.
• Not all safety systems are exactly the same, which is why we recommend you try your QUARTZ
out in the vehicle in which it is going to be used.
• It is very important not to use second hand products, because JANE can only guarantee com-
plete safety of products used by the original buyer.
• JANE recommends you replace your QUARTZ car safety seat with a new one if it has been
subjected to a lot of strain in an accident.
• Check that all the belts are correctly positioned and fastened to your QUARTZ. Make sure that
no belt is twisted.
• Make sure the child understands that he should never play with the seat belts or fasteners.
• The QUARTZ safety seat has been designed for use in the car and should not be used out of
the vehicle.
• For more information on the use and installation of the QUARTZ consult our web page www.
jane.es.
IM-1751 Quartz 13_10_15.indd 15
Understanding your QUARTZ car safety seat
Your QUARTZ safety seat has been designed using the latest safety developments and has been
tested under the strictest conditions. It is equipped with the following features:
To improve the child's safety:
• System to secure it to the vehicle using ISOfix anchors. These anchors are only used to fasten
the seat to the vehicle, the child should be secured with the vehicle 3-point seat belt.
• Headrest with 11 height positions to ensure maximum protection as the child grows.
• Higher sides, offering greater protection in the event of side impact.
• Impact absorbing material on the sides and middle of the headrest.
• Headrest reinforced against twisting.
To improve the comfort and fit for the child:
• Reclining seat, fitted with 3 positions.
OK
• Extra padding.
15
13/10/15 12:09