Fitting The Projector Plate To The Ceiling Plate - Epson ELPMB25 Guide De L'utilisateur

Secure the screws attached
to the hooks.
Put the supplied screws through
the screw holes and secure
them.

Fitting the Projector Plate to the Ceiling Plate

Procedure
Secure the screws at the height of these
marks so that the projector is set up almost
horizontally. Use them as a guide.
D
Secure the screw attached to the hook
using the M6 hexagon wrench. Put one of
the supplied screws into the screw hole
on the hook and secure it using the
hexagon wrench.
Fix the other three hooks in the same way,
by securing their screws.
Caution
Always use the screws supplied to secure the
projector and the projector plate.
A
Put the shaft of the projector plate into
the grooves of the ceiling plate and place
it securely in the horseshoe-shaped
points.
Do not release your hands from the
projector until mounting is complete.
B
Put the screws for the vertical angle
adjustment points that were removed
when removing the ceiling plate from the
projector plate in the screw holes.
Secure the two screws in the angle
adjustment points as shown in the left
illustration, using the supplied M8 hexagon
wrench to fix the projector. For details on
adjusting the angle of the projector, see the
next section "Adjusting the installation
angle".
25