Publicité
Les langues disponibles
Les langues disponibles
Instruction Manual for SD08/SD10 Light
Read Instructions Completely Before Installation & Save For Reference
Congratulations on the purchase of your quality built direct drive, wall exhaust ventilation fan. Used for general exhaust
ventilation, these fans come fully assembled and 100% of fans are tested for proper operation before shipping.
SD Exhaust Fans:
These models have a rugged, welded steel box housing with a powder coated finish and aluminum exhaust louvers. The
louvers open automatically when the fan starts up and close when the fan stops.
INSTALLATION
Installation is fast and simple. A sturdy framed wall opening should be prepared in advance to the size indicated for your fan in
the charts above. With lag bolts for wooden frames or nut, bolt and lock washers for steel frames, secure the fan using the
four mounting holes provided, one in each corner of the fan.
OPERATION
The fan has a cord and grounded plug. Plug the fan into a 115 Volt socket. Use the pull chain to turn fan off and adjust speed.
!
WARNING: FAN IS GUARDED ON INTERIOR. EXTERIOR SHOULD BE MOUNTED
WARNING
WARNING: MOTORS ARE EQUIPPED WITH AUTOMATIC OVERLOAD PROTECTION
Moving parts,
disconnect
power before
servicing.
MAINTENANCE
Motor, blade and louvers should be kept clean of any buildup to prevent premature motor failure and to achieve proper
performance. Automatic louvers should be kept operating freely. As with all mechanical equipment scheduled inspections
should include checking that all hardware is secure and blade set screws are tight.
This fan is provided with magnets on the shutters to prevent flapping and to hold them closed tightly when fan is not in
operation.
The fan should always be started on high speed to open the shutters. Once shuttes are open, it can then be operated on low
speed.
DO NOT PRESSURE WASH THE FAN.
CANARM LTD
2157 PARKEDALE AVE. P.O. BOX 367
BROCKVILLE, ONTARIO K6V5V6
TELEPHONE: (613) 342-5424
FAX: 1-800-263-4598
SD08_SD10-M 05/07/19
Commercial Wall Exhaust Fans
MODEL
SD08
SD10
AT LEAST 2.5 METERS ABOVE GRADE LEVEL OR PROPERLY
GUARDED FROM ACCIDENTAL CONTACT OF THE BLADE THROUGH
THE LOUVERS.
AND MAY RESTART WITHOUT WARNING. ALWAYS DISCONNECT
FROM POWER BEFORE ATTEMPTING SERVICE.
CANARM LTEE.
2555 RUE BERNARD LEFEBVRE
LAVAL, QUEBEC H7C 0A5
TELEPHONE: (450) 665-2535
FAX: (540) 665-0910
A X A
B
C
D (c/c)
SQUARE
13 1/4"
7 1/2"
4"
12"
15 1/4"
7 1/2"
4"
14"
N (# OF
E SQR
FRAMING
LOUVRES)
10 3/4"
2
11" x 11"
12 3/4"
3
13" x 13"
ARTHUR MANUFACTURING FACILITY
#7686 CONCESSION 16, RR4
ARTHUR, ONTARIO N0G 1A0
TELEPHONE: (519) 848-3910
FAX: (519) 848-3948
Page 2 of 2
Publicité
