Safety Regulations; Introduction; Symbols And Warning Notes; Information Symbols - Heiniger ONE Mode D'emploi

2 Safety regulations

2.1 Introduction

• This chapter describes the safety regulations that are to be taken into consideration as a
matter of course when using the shearing plant.
• All persons who carry out work on and with the shearing plant must read the
operating instructions.
• The operating instructions are to be kept in a secure place that is accessible at all
times.
• Only authorised service agents may carry out service and repair work.

2.2 Symbols and warning notes

Various symbols are used in the operating instructions. These symbols indicate possible
hazards or bring to the user's attention such technical information which, if not complied with,
may lead to personal injury and material damage or to uneconomic operation.
Hazard symbols
Warning
Denotes a possibly hazardous situation. Serious injury and even death can result if such situ-
ations are not avoided.
Caution
Denotes a possibly hazardous situation. Light or slight injury can result if such situations are
not avoided.

Information symbols

Note
A note which, if not complied with, can lead to operational stoppages or damage.
Diagram note
This symbol, complete with diagram number, denotes the corresponding diagram at the end
of the operating instructions.

2.3 Stipulated usage

The shearing plant's intended purpose of use is described in Chapter 1.2, « Purpose of use ».
Use for any other purpose, particularly on people and dangerous types of animals, especially
predators, is expressly forbidden.
Instruction Manual / Single speed shearing plant 5