LG WT7850H A Série Manuel Du Propriétaire page 47

Problem
Control panel has powered off due to inactivity.
• This is normal. Press the Power button to turn the washer on.
Washer is unplugged.
• Make sure cord is plugged securely into a working outlet.
Water supply is turned off.
• Turn both hot and cold faucets fully on.
Controls are not set properly.
• Make sure the cycle was set correctly, close the lid (door) and press the
Lid (Door) is open.
• The washer will not operate if the lid (door) is open. Close the lid (door) and
Circuit breaker/fuse is tripped/ blown.
• Check house circuit breakers/fuses. Replace fuses or reset breaker. The washer
Washer will not
operate.
Control needs to be reset.
• Press the Power button, then re-select the desired cycle and press the
Start/Pause was not pressed after a cycle was set.
• Press the Power button then re-select the desired cycle and press the
Extremely low water pressure.
• Check another faucet in the house to make sure that household water pressure is
Washer is too cold.
• If the washer has been exposed to temperatures below freezing for an extended
Start/Pause button.
make sure that nothing is caught under the lid (door) preventing it from closing
completely.
should be on a dedicated branch circuit. The washer will resume the cycle where
it stopped once power is restored.
Start/Pause button.
Start/Pause button. The washer will shut off if the Start/Pause button is not
pressed within 60 minutes.
adequate.
period of time, allow it to warm up before pressing the Power button. Otherwise,
the display will not come on.
Possible Cause & Solutions
TROUBLESHOOTING 47