LG WT7850H A Série Manuel Du Propriétaire page 42

42 TROUBLESHOOTING
Problem
The Control Lock function is on to prevent anyone from changing cycles or
operating the appliance.
CL
• Turn off Control Lock in the control panel. See Control Lock under Option
Special drain feature
• If the washer is paused during a cycle for more than 4 minutes, the cycle will be
dr
• This is not an error code. It indicates that the drain function is operating.
Lid (Door) is not closed properly.
• Close the lid (door) and press Start/Pause button. After starting a cycle, it may
dE
• If the error persists once the lid (door) is closed and the Start/Pause button is
Lid (Door) lock switch error.
• Make sure that the lid (door) is closed properly and press the Start/Pause button.
• Make sure that nothing is caught under the lid (door), including shipping material
dL
• Make sure that the latch mechanism is fully retracted.
• If the lid (door) is closed and the lid (door) lock error message is displayed, call
Foreign objects such as coins, pins, clips, etc., caught between the wash
plate and the inner basket.
• Turn the washer off then on again. Press the Spin button without selecting a
LE1
• When the Spin cycle is complete, empty the tub and find and remove any objects
• Always check pockets, etc., before washing to prevent error codes or damage to
It is time to run the Tub Clean cycle.
tcL
• Run the Tub Clean cycle.
The washer has detected an out of balance load.
• If the washer detects a load that is too far out of balance to spin, it will display this
vb
• As a result, the cycle will take longer than initially estimated.
Control error.
• Unplug the washer and wait 60 seconds. Reconnect power and try again. If the
tE
Water level is too high due to a faulty water valve.
FE
• Close the water faucets, unplug the washer, and call for service.
The water level sensor is not working correctly.
PE
• Close the water faucets, unplug the washer, and call for service.
Buttons.
cancelled and any water remaining in the tub will be drained.
take a few moments before the tub begins to turn or spin. The washer will not
spin unless the lid (door) is locked.
pressed, call for service.
The washer will not operate unless the lid (door) is locked.
or clothing.
for service.
cycle to drain and spin the load.
caught in the wash plate.
the washer or clothing.
code while it is attempting to rebalance the load. The washer will add water and
try to redistribute the load automatically. This display is for your information only,
and no action is required.
error reappears, call for service.
Possible Cause & Solutions