Operation; Installing/Removing The Battery Pack - Ego Power+ PH1400 Guide D'utilisation

OPERATION

WARNING:
Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
manufacturer of this product. The use of attachments or accessories not recommended
can result in serious personal injury.

INSTALLING/REMOVING THE BATTERY PACK

WARNING:
assembling parts, making adjustments, cleaning, or when not in use. Removing the
battery pack will prevent accidental starting that could cause serious personal injury.
NOTE: Fully charge the battery pack before first use.
To install battery pack (Fig. 5)
1. Align the ribs of the battery pack
with the mounting slots in the power
head's battery port.
2. Press the battery pack towards
the power head until it snaps into
position.
NOTE: Make sure that the latch on the
bottom of the battery pack snaps in place
and the battery pack is secured to the power head before beginning operation. Failure
to securely seat the battery pack could cause the battery pack to fall out, resulting in
serious personal injury.
Do not allow familiarity with this product to make you careless.
Always wear safety goggles or safety glasses with side shield
Do not use any attachments or accessories not recommended by the
Always remove the battery pack from the product when you are
56-VOLT LITHIUM-ION POWER HEAD—PH1400
5
Mounting Slot
Rib
17