ASG A680 Mode D'emploi page 9

OPERATING PROGRAM
Here is the detailed procedure to make the charger work. All the screens and operations will
take Li-Po BALANCE CHARGE program for example,
Connection
1). Connecting to power source
It is an AC charger only.
Please insert the AC power cord to the wall socket (100-240V) directly to power it on.
2). Connecting the battery
Important! Before connecting a battery it is absolutely essential to check one last time that
you have set the parameters correctly. If the settings are incorrect, the battery may be dam-
aged, and could even burst into flames or explode. To avoid short circuits between the banana
plugs, always connect the charge leads to the charger first, and only then to the battery.
Reverse the sequence when disconnecting the pack.
3). Balance Charge
The balance wire of the battery must be connected to the charger with the black wire aligned
with the negative mark. Always remember to keep right polarity in the connection. Please
refer to the wiring diagram below, which shows a correct way for your LiPo battery connection
in the balance charge mode.
In the other modes, there is no request to connect the balance wire to the balance socket in
the charger.
But we suggest to charge your battery in balance mode for better performance.