Warning And Safety Notes - ASG A680 Mode D'emploi

WARNING AND SAFETY NOTES

!
Never attempt to charge or discharge the following types of batteries:
A battery pack which consists of different types of cells (including different manufacturers).
A battery that is already fully charged or just slightly discharged.
Non-rechargeable batteries (explosion hazard).
Batteries that require a different charge technique from NiCd, NiMh, LiPo or Gel cell (Pb,
Lead acid).
A faulty or damaged battery.A battery fitted with an integral charge circuit or a protection
circuit.
Batteries installed in a device or which are electrically linked to other components.
Batteries that are not expressly stated by the manufacturer to be suitable for the currents
the charger delivers during the charge process.
!
Please bear in mind the following points before commencing charging: Did you
select the appropriate program suitable for the type of battery you are charging?
Did you set up the adequate current for charging or discharging?
Have you checked the battery voltage? Lithium battery packs can be wired in parallel and
in series, i.e. a 2 cell pack can be 3.7V (in parallel) or 7.4V (in series).
Have you checked that all connections are firm and secure?
Make sure there are no intermittent contacts at any point in the circuit.
!
Charging
During charge process, a specific quantity of electrical energy is fed into the battery. The
charge quantity is calculated by multiplying charge current by charge time. The maximum
permissible charge current varies depending on the battery type or its performance and
can be found in the information by the battery manufacturer. Only batteries that are
expressly stated to be capable of quick charge can be charged at rates higher than the
standard charge current.
Connect the battery to the terminal of the charger: red is positive and black is negative.
Due to the difference between resistance of cable and connector, the charger can not
detect resistance of the battery pack, the essential requirement for the charger to work
properly is that the charge lead should be of adequate conductor cross-selection, and high
quality connectors which are normally gold-plated should be fitted to both ends.
Always refer to the manual by the battery manufacturer about charging methods, rec-
ommended charging current and charging time. Especially, the lithium battery should be
charged according to the charging instruction provided by the manufacturer strictly.