Special Features - ASG A680 Mode D'emploi

SPECIAL FEATURES

Re-Peak Mode of NiMH/NiCd Battery
In re-peak charge mode, the charger can peak charge the battery once, twice or three times in a
row automatically. This is good for making certain the battery is fully charged.
Delta-peak Sensitivity for NiMH/NiCd
Delta-peak sensitivity for NiMH/NiCd battery: The automatic charge termination program based
on the principle of the Delta-peak voltage detection. When the battery's voltage exceeds the
threshold, the process will be terminated automatically.
Cyclic Charging/Discharging
1 to 5 cyclic and continuous process of charge > discharge or discharge > charge is operable for
battery refreshing and balancing to stimulate the battery's activity.
Automatic Charging Current Limit
You can set up the upper limit of the charging current when charging your NiMH or NiCd
battery, it is useful for the NiMH battery of low impedance and capacity in the 'AUTO' charging
mode.
Battery Meter
The user can check battery voltage and battery internal resistance.
Capacity Limit
The charging capacity is always calculated as the charging current multiplied by time. If the
charging capacity exceeds the limit, the process will be terminated automatically when you set
the maximum value.
Processing Time Limit:
You can also limit the maximum process time to avoid any possible defect.
DC Power Supply
Your A680 can supply DC power up to 60 Watts. You can use it to power devices that require
DC power.
Optimized Operating Software
A680 features the so-called AUTO function that set the feeding current during the process of
charging or discharging. Especially for lithium batteries, it can prevent the overcharging which
may lead to an explosion due to the user's fault. It can disconnect the circuit automatically and
alarm once detecting any malfunction. All the programs of this product were controlled through
two-way linkage and communication, to achieve the maximum safety and minimize the trouble.
All the settings can be configured by users!