ASG A680 Mode D'emploi page 7

OPERATION
BATT PROG / STOP Button
It is used to stop the progress or go back to previous step/screen
DEC Button:
It is used to go through the menus and decrease the parameter value
INC Button:
It is used to go through the menus and increase the parameter value
ENTER / START Button:
It is used to enter parameter or store parameter on screen.
When you are willing to alter the parameter value in the program, press the START/ENTER
button to make it blink then change the value by pressing DEC and INC button. The value will
be stored by re-pressing the START/ENTER button. If there is another parameter can be altered
in the same screen, when you confirm the first parameter value, the next parameter value will
start to blink which means it is ready to alert.
When you are willing to start the progress, press and hold the START/ENTER button for 3
seconds. When you are willing to stop the progress or go back to previous step/screen, press
the BATT PROG/STOP button once.
When you power on the charger, it will enter LiPo Battery balance program directly. You could
change the mode (balance mode, normal charge mode, fast charge mode, store mode or
discharge mode), enter the desired charging/discharging mode, set the referred parameter and
start the progress.
If you have no request for LiPo Battery program, please press the BATT PROG/STOP button to
enter BATT PROGRAM screen.