Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Failure to connect as shown in this diagram will damage this charger. To avoid short circuit
between the charge lead always connect the charge cable to the charger first, then connect
the battery. Reverse the sequence when disconnecting.
OPERATING PROGRAM
Getting started
Locate the flowcharts showing the entire programming menu. It is highly recommended to
have these flowcharts handy while learning to operate this charger. There are two main ways
in which to set the charger.
1)
A memory profile is available for setting and storing pertinent information for 10
different program sets. Once a battery program is stored into memory, it will be re-
tained until changed again manually. Recalling a program memory number makes
the charger instantly ready to go.
2)
If you do not wish to use the battery program memories, this charger can be
manually set before each use.
Publicité
Table des Matières
