ASG A680 Mode D'emploi page 16

8. Program stop
During the charging process, press STOP to stop the charging process
9. Program Complete
When the charging process finishes, an audible sound will be heard.
Charging program
Depending on different battery type, the operation programs are different.
Batt Type Operation Program
CHARGE
DISCHARGE
LiPo
STORAGE
LiHV
Lilon
FAST CHG
LiFe
BAL CHARGE
CHARGE
AUTO CHG
NiMH
NiCd
DISCHARGE
RE-PEAK
CYCLE
NORMAL CHG
AGM CHG
Pb
COLD CHG
DISCHARGE
This charging mode is for charging LiPo/LiHV/LiFe/Lilon battery in normal mode.
This mode is for discharging LiPo/LiHV/LiFe/Lilon battery.
This program is for charging or discharging lithium battery which will not be
The charging capacity may be a bit smaller than normal charging, but the
process time will be reduced.
This mode is for balancing the voltage of lithium-polymer battery cells while
The charger will charge NiMH and NiCd batteries using the charge current set
In this program the charger detects the condition of the battery which is con-
nected to the output and automatically charges the battery.
Note: You should set up the upper limit of the charge current to avoid damage
by excessive feeding current. Some batteries of low resistance and capacity can
lead to higher current.
This mode is for discharging NiMH/NiCd battery.
In re-peak charge mode, the charger can peak charge the battery once, twice or
three times in a row automatically. This is good for confirming the battery is fully
charged, and for checking how well the battery receives fast charges.
1 to 5 cyclic and continuous process of charge>discharge or discharge>charge is
operable for battery refreshing and balancing to stimulate the battery's activity.
This mode is for charging Pb battery.
This mode is for charging AGM battery.
This mode is for charging Pb battery in cold days when the temperature is 5°C
This mode is for discharging Pb battery.
Description
used for a long time.
charging.
by the user.
to -20°C.