Before Use - Teac TC-X350i Mode D'emploi

What's in the box
Confirm the supplied standard accessories.
AC power cord x 1
Remote control unit (RC-1273) x 1
(CR2025 Battery x 1 included)
Speaker x 2
Speaker cable x 2
iPod dock x 1
Dock adapter x 2
AM loop antenna x 1
FM lead-type antenna x 1
Owner's manual (this document) x 1
< Keep this manual in a safe place for future reference.
Warranty card x 1

Before Use

Placement of the unit
< Choose the installation location of your unit carefully. Avoid placing
it in direct sunlight or close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold or moisture.
< As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation.
Make sure there is at least 8" (20 cm) of space above and at least 2"
(5 cm) of space on each side of the unit. Do not place anything on
top of the unit.
< Do not place the unit on an amplifier or receiver or any other
device that generates heat.
CAUTION
< Do not move the unit during disc playback.
During playback, the disc rotates at high speed. Do not lift or
move the unit during playback. Doing so may damage the disc
or the unit.
< The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
< Do not open the cabinet as this might result in damage to the
circuitry or electrical shock. If a foreign object should get into the
unit, contact your dealer or service company.
< When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord.
< Always remove the disc before relocating or moving this unit.
Moving the unit with a disc inside it could cause malfunction.
Maintenance
If the surface of the unit gets dirty, wipe it with a soft cloth or
use diluted mild liquid soap. Allow the surface of the unit to dry
completely before using.
For safety, disconnect the power cord from the socket before
cleaning.
< Never spray liquid directly on this unit.
< Do not use thinner, benzene or alcohol as they could damage the
surface of the unit.
Beware of condensation
When the unit is moved from a cold to a warm place, or used after a
sudden temperature change, there is a danger of condensation on
the lens of CD player; vapor in the air could condense on the internal
mechanism, making correct operation impossible. To prevent this, or
if this occurs, leave the unit turned on for one or two hours. Then the
unit will stabilize at the temperature of its surroundings.
5