Icon Explanations; Controller Operation - Mitsubishi Electric PAR-30MAOA Manuel D'instructions

Not all functions are available on all models of indoor units.

Icon explanations

Controller operation

Timer
The administrator or maintenance user password must be entered
P
on the password input screen to change settings. There is no
settings that can skip this process.
Timer
Enter administrator password
Select:
Cursor
F1 F2 F3
Indicates settings that can
ON
be changed only while the
units are in operation.
Indicates settings that can
be changed only while the
units are operated in the
Cool, Heat, or Auto mode.
Service
Test run ....................................
Input maintenance info. ...........
Function setting .......................
Lossnay ...................................
Check ......................................
Self check ................................
Maintenance password ............
Remote controller check ..........
P
F1 : Press to move the cursor left.
F2 : Press to move the cursor right.
F3 : Press to decrease the value by 1.
F4 : Press to increase the value by 1.
* Changes cannot be made unless the
F4
correct password is entered.
Indicates settings that can be changed only
OFF
while the units are not in operation.
Indicates functions that are not available
when the buttons are locked or the system
is centrally controlled.
Refer to the indoor unit Installation
Manual.
Refer to the indoor unit Installation
Manual.
Refer to page 57.
Refer to the Installation Manual.
Refer to the indoor unit Installation
Manual.
Refer to the Installation Manual.
Refer to the Installation Manual.
Refer to the Installation Manual.
The table below summarizes
the square icons used in this
manual.
Main
Indicates
settings that
can be made
only from the
main remote
controller.
11