Controls; Lint Filter - GE DSKP233 Manuel Du Propriétaire

About the dryer control panel.
You can locate your model number on the label on the front of the dryer behind the door.
Push To Start
2
Control Settings and Features
IMPORTANT: Clean the lint filter each time you use the dryer.
Drying Cycles
1
PERM. PRESS/REG. For most normal loads. For most loads select the Preferred Regular Setting marked with an
TIMED DRYING Set the Cycle Selector at the desired drying time.
Start
— Close the dryer door. Press the START button to start the dryer. Opening the door during operation
2
will stop the dryer. To restart the dryer, close the door and select START to complete the cycle.
End of Cycle Signal

Lint Filter

— Clean the lint filter each time the dryer is used. Always be sure the lint filter is in place. The lint screen
is located inside the dryer drum, on the back wall.
To clean:
Use the finger holes to pull the
1
lint screen straight out.
Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size
of load, types of fabrics, wetness of clothes and condition of exhaust ducts.
6
Spacemaker Dryer
— Automatic cycles automatically determine fabric dryness. Select MORE for heavier fabrics,
LESS for lighter fabrics. Timed cycles run for the selected time.
AIR For removing wrinkles from items that are clean and dry or that are very lightly damp.
— This operates with any cycle. The signal will sound just before the end of the cycle to
remind you to remove the clothes.
WARNING: Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating, damage fabrics and be a fire hazard.
Lightly squeeze the body as
2
shown while pulling the cover off.
ROLL lint off the screen with
3
your fingers. Do not rinse or wash
the screen.
ENERGY PREFERRED
AUTOMATIC SETTING
1
Replace the cover on the body of
4
the lint screen.
Before replacing the lint screen,
5
remove any lint from the wire
mesh on the back wall (behind
the lint screen).
Push the lint screen straight back
6
until it snaps into place.
* .