Starting Up; Filling The Stone Container; Using The Ceramic Bowl - Sentiotec Concept R combi Mode D'emploi

Instructions for use for the user

5. Starting up

5.1. Filling the stone container

WARNING!
Risk of fire due to overheating
If the sauna heater is used without sauna stones, the cabin walls will
become extremely hot. This could cause fires.
● NEVER operate the sauna heater without the sauna stones.
The amount of stones suited to your heater output can be found in chapter
10. Technical data (see page 26).
1. Wash the stones thoroughly before use using water and a brush. Do not
use any cleaning additives.
2. Before filling the heater with the sauna stones, check them for foreign objects
and remove any remaining packaging.
3. Place the stones in the stone container. Place sauna stones loosely so that
air can flow through the gaps.
4. Make sure that the sauna stones do stick out over the edge of the stone
container.

5.2. Using the ceramic bowl

● Place the ceramic bowl on the
evaporator tank as shown in the
illustration on the right.
WORLD OF WELLNESS
p. 16/26