Install The Exhaust Duct - Novy 828 Instructions D'installation

Installation method 2:
6
• Fully unscrew the 4 screws (906136) on top of the built-in unit. If necessary, remove the clamping springs on the
side.
• Make the cut-away for the exhaust duct and the 4 attachment screws in the partition.
• Position the built-in unit in the recessed housing onto the partition.
• Screw the built-in unit onto the partition with the 4 screws (906136).

Install the exhaust duct

The motor outlet has a diameter of 150 mm. It is recommended to connect an exhaust duct with a diameter of 150
7
mm to this. A reducer is supplied with the hood. Only mount the reducer when using an exhaust duct with a diameter
of 125 mm.
For optimum performance of the hood it is important to pay attention to the points given below.
INSTALL THE EXHAUST DUCT
The exhaust of the hood must be properly taken care of. For optimum performance of the hood it is important to pay
attention to the following items during the installation:
• Use smooth, non-flammable pipes with an internal diameter that is equal to the external diameter of the connection
nozzle of the hood. Maximally extend flexible ducts and cut them to size.
• Do not reduce the exhaust diameter. This will lower the capacity and raise the noise level.
• Make the duct as short as possible and with as few as possible bends to the outside.
• Avoid square bends. Use rounded bends for proper air conduction.
• Flat duct: the surface of a flat duct must be the same size as Ø150 mm = 177 cm².
• In case of an exhaust pipe through the outside wall passing a cavity wall, make sure that the exhaust duct fully bridges
the cavity and slightly declines to the outside.
• When connecting to a short exhaust duct, it may be required to mount a non-return valve in the duct to avoid wind-
blowing in.
• Use a hose clamp or aluminum tape for airtight connections.
• In case of an exhaust pipe through the roof, use a double-walled roof passage with sufficient width.
• Never connect to a flue duct.
• Make sure that sufficient air is supplied. Fresh air can be supplied by slightly opening a window or an outside door or
by installing an inlet grate.
EN 10