Troubleshooting - Breville Fountain Plus Manuel D'instructions

Troubleshooting

PROBLEM
Machine will not work
when turned ON
Motor appears to
stall when juicing
Excess pulp building
up in the stainless
steel filter basket
Pulp too wet
and reduced
extracted juice
Juice leaks between
the rim of the juicer
and the juicer cover
Juice sprays out
from spout
16
JE98XL_IB_G16.indd 16 JE98 8 XL_IB_G16.indd 16
EASY SOLUTION
•
The safety locking arm may not be correctly engaged in the vertical operating
position with the locking arm located into the two grooves on either side of the
juicer cover.
•
Wet pulp can build up under the juicer cover if the juicing action is too vigorous.
Try slower juicing action by pushing the food pusher down slower. Follow
Disassembling and Cleaning instructions and clean the filter bowl surround, the
stainless steel filter basket and the juicer cover.
•
Hard fruit and vegetables will put excess strain onto the motor if a low speed is
selected. Please refer to the juicing guide to determine the correct speed for the
fruit and vegetables selected for juicing.
•
Stop the juicing process and follow Disassembling instructions. Remove the
juicer cover, scrape off pulp, reassemble and begin juicing again. Try alternating
(soft and hard) vegetables and fruit varieties.
•
Try a slower juicing action. Remove the stainless steel filter basket and
thoroughly clean mesh walls with a cleaning brush. Rinse the filter basket under
hot water. If the fine mesh holes are blocked, soak the basket in a solution of hot
water with 10% lemon juice to unblock the holes or wash in the dishwasher. This
will remove excess fiber build up (from fruit and vegetables) which could be
inhibiting the flow.
•
Try a slower juicing speed and push the food pusher down the feed chute slower.
•
The juice is being extracted too fast. Try a slower juicing speed and push the
food pusher down the feed chute slower.
29/0 /01/2 /2016 2:19 pm