Troubleshooting - Breville Juice Fountain Compact Manuel D'instructions

Troubleshooting

PROBLEM
Machine will not work
when turned ON
Motor appears to
stall when juicing
Excess pulp building
up in the Nutri Disc™
Pulp too wet and reduced
extracted juice
Juice leaks between the rim
of the juicer and the cover of
the filter
Bowl container juice
sprays out from spout
Juicer makes loud noise
when turned on
No juice coming out
while juicing
18
EASY SOLUTION
•
The safety locking arm may not be correctly engaged in the vertical
operating position with the locking arm located into the two grooves on
either side of the juicer cover.
•
Wet pulp can build up under the cover if the juicing action is too
vigorous. Try slower juicing action by pushing the food pusher down
slower. Clean the integrated pulp container, the Nutri Disc™ and the
juicer cover.
•
Stop the juicing process. Remove the juicer cover, scrape off pulp.
Re-assemble and begin juicing again. Try alternating (soft and hard)
vegetable and fruit varieties.
•
Try a slower juicing action by pushing the food pusher down slower.
Remove Nutri Disc™ and thoroughly clean mesh walls with the nylon
brush. Rinse the Nutri Disc™ under hot water. If the fine mesh holes are
blocked, soak the Nutri Disc™ in a solution of hot water with 10% lemon
juice to unblock the holes or wash in the dishwasher. This will remove
excess fiber build up (from fruit or vegetables) which could be inhibiting
the juice flow.
•
Try a slower juicing action by pushing the food pusher down slower.
•
Try a slower juicing action by pushing the food pusher down slower.
•
Nutri Disc™ is not properly locked into position. Turn the ON/OFF
button to OFF and unplug.
•
Disassemble the juicer (refer to disassembling).
•
Re-assemble (refer to assembly).
•
Check that the spout is not blocked with pulp.
•
Refer to care and cleaning.