Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of the maintenance.
WARNING!
Maintenance operations must be carried out with the machine switched off and the power supply cable
disconnected from the electrical mains.
Moreover, carefully read all the instructions in the Safety chapter.
All scheduled or extraordinary maintenance operations must be performed by qualified personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures contained in the scheduled maintenance table, see the specific Service
Manual that can be consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Operation
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and replacement
Solution filter cleaning
Screw and nut tightening check
Vacuum system motor carbon brush check or replacement
(1):And after the first 8 working hours
(2):This maintenance operation must be performed by KENT authorized Service Center.
SQUEEGEE CLEANING
NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
CAUTION!
It is advisable to use protective gloves when cleaning the squeegee because there may be cutting debris.
1.
Drive the machine on a level ground.
2.
Make sure that the power supply cable (21, Fig. C) is disconnected from the electrical mains.
3.
Lower the squeegee by means of the lever (19, Fig. C).
4.
Disconnect the vacuum hose (22, Fig. C) from the squeegee.
5.
Loosen the handwheels (12, Fig. C) and remove the squeegee (11).
6.
Wash and clean the squeegee. In particular, clean the compartments (1, Fig. E) and the vacuum hole (2) from dirt and
debris.
7.
Check the front blade (3) and the rear blade (4) for integrity, cuts and tears; otherwise replace them (see the procedure in
the next paragraph).
8.
Assemble in the reverse order of disassembly.
Razor E17 — 909 6311 000(1)2006-01
INSTRUCTIONS FOR USE
Daily or after
using the
Weekly
machine
Every six
Yearly
months
(1)
(2)
9
Publicité
Chapitres
Dépannage
