Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - KENT 26D Instructions D'utilisation

INSTRUCTIONS FOR USE

INTRODUCTION

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all
necessary information to use the machine properly, in a safe
and autonomous way. It contains information about technical
data, safety, operation, storage, maintenance, spare parts
and disposal.
Before carrying out any procedure on the machine, the
operators and qualified technicians must read this Manual
carefully. Contact KENT in case of doubts concerning the
interpretation of the instructions and for any further
information.

TARGET

This Manual is intended for operators and technicians
qualified to perform the machine maintenance.
The operators must not carry out procedures reserved for
qualified technicians. KENT will not be answerable for
damages coming from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Instructions for Use Manual must be kept near the
machine, inside an adequate case, away from liquids and
other substances that can cause damage to it.

IDENTIFICATION DATA

The machine serial number and model are shown on the plate
(30, Fig. C) on the steering column.
The machine model year is shown after the Date Code on the
serial plate (A06 means January 2006).
This information is useful when requiring machine spare
parts. Use the following table to write down the machine
identification data.
MACHINE model ...........................................................
MACHINE serial number ...............................................
2

OTHER REFERENCE MANUALS

– Electronic battery charger Manual (to be considered as
integral part of this Manual)
Moreover, the following Manuals are available:
– Service Manual (that can be consulted at KENT Service
Centers).
– Spare Parts List (supplied with the machine)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures
must be carried out by qualified personnel or by KENT
Service Centers. Only original spare parts and accessories
must be used.
Contact KENT for service or to order spare parts and
accessories, specifying the machine model and serial
number.

CHANGES AND IMPROVEMENTS

KENT constantly improves its products and reserves the right
to make changes and improvements at its discretion without
being obliged to apply such benefits to the machines that
were previously sold.
Any change and/or addition of accessory must be approved
and performed by KENT.
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11