Adjust The Saw Carriage - Dimas WS 462 Mode D'emploi

Start by loosening the marked nuts (1) with the supplied
special tool. Now loosen the two stop screws (2). When
these are loose, adjust the guide wheels (3) against the
rail by turning them towards the rail so the play is taken
up. Hold the guide wheels and screw in the stop screw.
Now screw on the nuts to secure the guide wheels in the
new position.
2
3
Grease the blade spindle:
In order for the blade spindle to be fitted as easily as
possible, it may be necessary to grease the hexagonal
blade spindle. At the same time check that the hexagon is
not damaged.
16 - English
1

Adjust the saw carriage:

As the saw wears, after a number of hours working, it can
be a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs
adjusting:
Loosen the marked (1) socket headed screw (one on each
side of the handle). Now turn the eccentric axles (2) with
the help of the supplied special tool until the axle lies tight
against the saw. Now tighten the socket headed screw.
1
Operator's Manual WS 462
2