JVC KD-R771BTM Manuel D'instructions page 12

BLUETOOTH®
To
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
Improve the voice quality
While talking on the phone....
1 Press and hold .
2 Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
MIC LEVEL
–10 — +10 (–4): The sensitivity of the microphone increases as the number increased.
NOISE RDCT –5 — +5 (0): Adjust the noise reduction level until the least noise is being heard
during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation delay time until the least echo is being
heard during a phone conversation.
10
On the faceplate
Press and hold or the
volume knob.
Press .
Turn the volume knob
during a call.
• This adjustment will not
affect the volume of the
other sources.
Press during a call.
• Operations may vary
according to the connected
Bluetooth device.
.
Make the settings for receiving a call
On the remote control
1
Press
2
Turn the volume knob to select an item (see the
Press and hold
following table), then press the knob.
.
3
Repeat step
activated.
( Not available )
To return to the previous setting item, press
( Not available )
SETTINGS
AUTO ANSWER
( Not available )
RING ILLUMI
Default: XX
to enter Bluetooth mode.
2
until the desired item is selected or
01 SEC — 30 SEC: The unit answers incoming call
automatically in the selected time (in seconds). ;
OFF: Cancels.
BLINK 1 — BLINK 5 (BLINK 2): Selects the notification
blinking pattern for the buttons when there is an
incoming call. ; OFF : Cancels.
.
Default: XX