Mounting - Lupine Betty R Manuel D'utilisation

2

Mounting

Helmet bracket:
The Lupine helmet bracket can be attached to virtually
any helmet that has ventilation slits. The bracket is easy
to mount. For further information, see the text and
pictures on the pages that follow.
Helpful hints:
mounting and removing the bracket once, because once you've snipped off the extra length,
you can't put it back on again.
1 1
Make the straps as tight as possible by pulling hard on
them, and in such a way that the bracket is centered.
After pressing the two velcro elements (upper and
lower strap) together, tuck the trailing ends of the
velcro under your helmet to avoid unsightly "ears. "
Grasp the bracket and move it back and forth with
moderate force, to make sure that it is firmly in place.
28 Betty R
Normally the two straps are too long. However, only shorten them after
Pull both straps through the best situated ventilation
slits. Try out various options until you find the optimal
position. Since virtually all ventilation slits are raked for-
ward, its best to mount the bracket as far as possible un-
der the edge of the helmet, to prevent the bracket from
slipping. In doing this, thread the two straps through the
slits as shown in the picture.
Hint: Sometimes it is easier to install the helmet mount
without attached light. Remove the lamphead by help
of the included size 3 allen key.
2