Make A Call - JVC KD-X470BHS Manuel D'instructions

Bluetooth®
*1 This adjustment will not affect the volume of the other sources.
*2 Press and hold VOL + to continuously increase the volume to 15.
*3 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[MIC GAIN] [LEVEL –10] to [LEVEL +10] ([LEVEL –04]): The sensitivity of the
microphone increases as the number increases.
[NR LEVEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
[SETTINGS]
[AUTO ANSWER] [01 SEC] to [30 SEC]: Answers an incoming call automatically in the selected
[RING COLOR]
[RING ILLUMI]
.
Default: [XX]

Make a call

You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
2
3
To return to the previous setting item, press
.
time (in seconds). ; [OFF]: Cancels.
KD-X470BHS/KD-X370BTS/KD-X37MBS:
[COLOR 01] to [COLOR 49] ([COLOR 08]): Selects the illumination color for
the buttons as notification when there is an incoming call and during a call. ;
[OFF]: Cancels.
KD-X270BT/KD-SX26BT:
[BLINK 01] to [BLINK 05] ([BLINK 02]): Selects the blinking pattern for the
buttons as notification when there is an incoming call. ; [OFF]: Cancels.
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
the other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (page 24), then press the
knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Default: [XX]
again to switch to
.
23
ENGLISH