Starting The Engine; Stopping The Engine - Wolf Garten A 530 A SP HW IS Manuel D'instructions

English
Disposal information for the
charger
The charger is subject to the dis-
posal regulations for electrical
appliances. Observe the local regu-
lations.
Always adjust machine
before using
Risk of injury
!
Before carrying out any work on
this mower
– Switch off the engine
– Remove the ignition key (if used),
– Wait until all moving parts have
come to a standstill; the engine
must have cooled down,
– Remove the spark plug con
nector on the engine in order to
prevent the engine from acciden
tally being started,
– Remove the starter accumulator
from the engine.
Hang the grass catcher
(only in the case of appliances with
grass catchers)
Fig. 11
Lift up the deflector flap and hook

the grass sack onto the lawn
scarifier.
Set the cutting height
Caution
Select cutting height for uneven ter
rain to prevent the cutter from ever
coming into contact with the
ground.
Fig. 3 and 4
Set the cutting height of the grass
as required.
Setting option (depending on
model) from approx. 3 cm to
maximum 9 cm.
Note
If appliances have individual wheel
adjustment, set all wheels to the
same height.
Model A – fig. 3
Pull the flap and snap into place

in the position required.
12
Model B – fig. 4
Advance or push back the lever

of the central vertical adjustment
and snap into place in the
position required.
Fill up with fuel and check the
oil level
Fill up with lead-free petrol (see

engine manual).
Fill fuel tank up to max. 2 cm

below the lower edge of the inlet
nozzle.
Close fuel tank tightly.

Check oil level and, if required,

top up (see Engine manual).
Cleaning the battery
compartment on the engine
-
Remove foreign objects and dirt

from the battery compartment
-
using a cloth and brush.

Starting the engine

Fig. 5
Danger
!
To prevent injury:
– Do not start the engine when you
are standing in front of the
ejector;
– Keep hands and feet well away
from the cutting blade;
– never place your hands, feet, or
other parts of the body near
rotating parts; Always keep away
-
from the ejector.
Before starting the engine, disen
gage the clutches for all cutters and
drives.
Do not tip the appliance when start
ing. Keep the appliance on an even
surface with little or the shortest
possible grass.
Information about the engine
– Observe the information in the
engine manual.
– Some models have no throttle
and the speed is adjusted
automatically. The engine
always runs at optimum speed.
Insert the starter accumulator

into the respective compartment
on the engine until it engages –
Fig. 5A.
Open the fuel tap (if fitted).

Operating Instruction – Lawnmower with IC engine
Set throttle (if available) to

/max – Fig. 5B
Stand behind lawnmower –

Press and hold safety hoop –
Fig. 5C.
Turn ignition key on the steering

handle until the engine starts
(start attempt max. 5 seconds,
wait at least 1 minute before the
next attempt) – Fig. 5C.
When the engine is running:
When the engine has started,

push the throttle (if fitted)
between
warm up the engine briefly.
Set the throttle to full throttle

(if available).
Note
If you need more information about
operating the engine, please refer
to the engine manual.

Stopping the engine

Fig. 7
Bring throttle (if available) into

position
Release the safety lever. The

engine and the cutting tool stop
after a short time.
Working with the appliance
Engaging/disengaging gear
drive
(only in the case of appliances with
gear drives)
-
Fig. 6
Putting gear drive into gear
Push the wheel drive lever (2)

-
together with the safety lever (1)
forward. The further they are
pressed forwards, the faster the
appliance moves.
Throwing gear drive out of
gear
Pull the wheel drive lever (2)

together with the safety lever (1)
fully back.
Note
When the unit is pulled back, there
may be increased resistance on the
back wheels on account of the
design.
/max and /min to
/min.
:
: