Mounting And Electrical Connection; Dimension Drawing And Control Elements - Knick PolyTrans P 32000 P0 Série Mode D'emploi

Mounting and Electrical Connection

The transmitters are snapped onto a TS 35 standard rail and are
laterally fi xed by suitable end brackets.
See dimension drawing for terminal assignments.
Wire cross-section: 0.2 mm

Dimension Drawing and Control Elements

Operation LED (green)
Pushbutton
1 Input 1 +
2 Input 2 +
3 Input 3 -
4 Input 4 -
5 Output +
6 Output -
7 Power supply
8 Power supply
44
2
... 2.5 mm
Hole for pushbutton
Status LED (yellow)
Signal LED (red)
93 mm
9 Start value (2 rotary switches)
10 End value (2 rotary switches)
11 DIP switches with the following assignments:
1,2,3: Sensor selection
4,5:
6:
7,8:
12 Model P 32xxx P0/x0 only:
24 VDC power supply via DIN rail bus connector
2
(AWG 24-14).
Factor for start value
Factor for end value
Output signal selection