Periodical Maintenance - SilverCrest SDR 1000 A1 Mode D'emploi

__GRA86100_B1.book Seite 102 Montag, 3. Dezember 2012 1:31 13
• Clean the shaving head|2 and the cutter block|20 only un-
der cold, running tap water. Do not use warm water, clean-
ing agents or any other additives.
• Do not apply excessive pressure to the shaving foil|1. It is
thin and easily damaged.
• Use the cleaning brush|19 only to clean the cutter block|20,
never to clean the shaving foil|1.
NOTE: To ensure a smooth shave at all times, the appliance
must be cleaned and maintained regularly.
Cleaning after each shave
1. Press both release buttons|3 and take off the shaving head|2.
2. Carefully tap any loose debris out of the shaving head|2.
3. Clean the cutter block|20 with the cleaning brush|19.
4. Rinse off the cutter block|20 and the shaving head|2 under
cold, running water.
5. Attachments |11 /|12 /|13 may be washed in warm water
with a little added mild soap.
6. Let all parts dry completely.
7. Click the shaving head|2 into position on the appliance.

Periodical maintenance

• As required, wipe the appliance (not the shaving foil|1)
with a slightly moistened cloth.
• Check the shaving foil|1 regularly for damage and replace it
if necessary as described in the Chapter "Replacing the
shaving foil" on page 103.
• Depending on the intensity of use, but at least every six|months,
carefully spread a little sewing machine oil onto the shaving
foil|1 with your finger.
102
GB