Setting The Transmission Power; Adjusting The Transmission Channel; Operation - IMG STAGELINE TXS-611SET Mode D'emploi

4.3 Setting the transmission power

On the wireless microphone, adjust the trans-
mission power with the switch POWER (19) in
the battery compartment:
– upper position HI = high power for a long
transmission range, but reduced battery life
– lower position LO = low power for a long
battery life, but reduced transmission range

4.4 Adjusting the transmission channel

To adjust a free transmission channel on the re-
ceiver, either use the automatic scan function or
adjust the channel manually . Then simply press
a button to adjust the wireless microphone to
the same channel via IR signal .
1) Switch on the receiver with the POWER
switch (9) . To switch on the microphone,
set the switch (16) to the upper position .
After switching on, the corresponding display
(3, 14) lights up .
2) To automatically scan a free channel, press
the button SELECT (2) briefly . To indicate the
scan, one segment of the numerical display
element starts moving around on the dis-
play (3):
After a short while, the display shows the
number of the channel found . The corre-
sponding frequency can be found in the table
on page 3 .
3) To manually adjust a specific transmission
frequency, find the corresponding channel
number in the table on page 3 . To adjust the
channel number, keep the button SELECT (2)
pressed until the units digit on the display (3)
starts flashing . Press the button briefly to ad-
just the units digit . Keep the button pressed
again until the tens digit on the display starts
flashing . Press the button briefly to adjust
the tens digit . A few seconds after you have
pressed the button for the last time, the tens
digit will stop flashing to indicate that the
channel adjustment has been stored .
4) Point the IR sensor (15) of the microphone
towards the IR window (6) on the receiver .
10
The distance must not exceed 1 .5 m . Make
sure that there are no obstacles between the
sensor and the IR window .
Keep the button ACT (7) pressed for a
few seconds until the display backlight of the
microphone has been activated . Thus, the
microphone and the receiver have been set
to the same channel . The display (14) shows
the channel number .

5 Operation

1) Put the receiving antennas (1) in a vertical
position .
2) Switch on the receiver with the POWER
switch (9) first . The LED AF (4) flashes twice .
The display (3) shows the transmission chan-
nel adjusted .
If one of the reception LEDs RF (5) lights
up while the wireless microphone is still
switched off, interfering signals or signals
from another wireless system are received . In
this case, adjust a different channel (
ter 4 .4) .
3) To switch on the microphone, set the switch
(16) to the upper position . In the mid-
position, the microphone is also switched
on, but the microphone signal is muted .
After switching on, the backlight of the
display (14) lights up for a few seconds . The
display shows the channel adjusted and the
battery status:
BATT
full
Note: Replace the batteries when the indication
BATT starts flashing .
4) When the microphone is switched on, one
of the reception LEDs RF A or B (5) lights up
on the receiver to indicate which receiving
part supplies the best signal . If none of them
lights up, please check:
a Have the microphone and the receiver
been set to the same channel?
If different channels are indicated on the
receiver and on the microphone, proceed
with step 4 of chapter 4 .4 .
chap-
☞
BATT BATT
discharged