Friedrich QuietMaster Programmable SS08 Manuel D'installation Et Mode D'emploi page 13

STEP 11 INSTALL THE SIDE WINGBOARD PANELS – Be sure the
a c i b e n h t s a e b n e e s
side support brackets have been installed as shown in Figure
D. Raise the window sash and install the right and left side
wingboard panels. (See Figure G).
STEP 12 INSTALL THE WINDOW SEALING GASKETS – Measure
and cut the vinyl window seal gasket (grey color, Item # 12) to
t the width of the window, and install as shown in Figure H.
Pull the window sash down behind the gasket. Measure and
cut the dark foam window seal gasket (Item #13) and install it
between the upper glass panel and the top part of the lower
sash. (See Figure H).
NOTE: FOR REASONS OF SECURITY AND SAFETY, THE
C U T S O M E R M U T S
THE WINDOW FROM OPENING.
STEP 13 When possible, caulk the outside of the installation with
n i u d r t s l a i y t e p c u a i k l
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
Figure G
SECURE THE SIDE WINGBOARD PANELS TO
THE SIDE ANGLES WITH FOUR (4) #8 x ½" LONG
SCREWS (ITEM #11), TWO ON EACH SIDE.
TOP OF CABINET
PLACE WINGBOARD PANEL IN
WINDOW JAM TO COMPRESS THE
SPRINGS INSIDE THE RUNNERS,
AND SWING THE PANEL INTO PLACE
INDICATED BY THE DOTTED LINE.
SECTION A - A
u c e r t d t o e h w n i o d w l l i s n a t d a h
P R O V D I E A M E A N S O F P R E V
g n o t p e r e v t n w a e h t r e e l k a . s
WINDOW JAM
920-198-01
t t e h o - t u
STEP 14
E N T N I G
STEP 15
Figure H
INSERT VINYL WINDOW SEAL
GASKET OVER TOP ANGLE
TO WINGBOARD (ITEM #12)
VINYL
WINDOW
GASKET
CAUTION
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit.
Failure to do so can result in minor
to moderate personal injury.
INSTALL CHASSIS – After installing the shell, slide the chassis
into the shell stopping approximately 3" from full insertion. Stuff
the chassis seal gasket one inch deep between the chassis
and the shell (see Figure I). Begin at either bottom corner and
go up the side, across the top, and down the opposite side. Then
push the chassis all the way into the shell for the remaining distance
so that the plastic front meets the front edge of the shell.
If chassis seal gasket is not installed, the operation of the unit
will be negatively affected. Operational noise and outside
noise will also be ampli ed.
Reattach the chassis retainer wire with the same screw as in
Step 3 (See Figure A).
INSERT FOAM WINDOW
SEAL GASKET (ITEM # 13)
LOWER WINDOW SASH
TOP WINGBOARD ANGLE
SECTION B - B
13