Davey EcoMatic COMM500 Instructions D'installation Et D'utilisation page 60

Aplique fita de Teflon no fio do interruptor de caudal e aparafuse o interruptor de caudal à abraçadeira do
tubo. Aperte o interruptor de caudal utilizando as chaves de bocas planas no corpo. Evite apertar o interrup-
tor via o quadro elétrico, uma vez que pode danificar o interruptor.
O alinhamento do interruptor é crítico para corrigir a operação. O interruptor deve estar alinhado com o tubo
e a seta do caudal ma direção do caudal. Retire a tampa do quadro elétrico e introduza os cabos na entrada
de cabos. Ligue os cabos aos terminais identificados como "COMM" e "NO".
Encaixe a tampa no quadro elétrico e fixe-a com o parafuso. Desligue o sensor de gás da célula.
to prevent leakage.
Position the lower half of the pipe clamp onto the pipe and secure with the fasteners provid
Position the lower half of the pipe clamp onto the pipe and secure with the fasteners provid
to prevent leakage.
to prevent leakage.
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
switch using the spanner flats on the body. Avoid tightening the switch via the electrical enc
damage the switch.
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
Apply Teflon tape to the thread on the flow switch and screw the flow switch into the pipe c
switch using the spanner flats on the body. Avoid tightening the switch via the electrical enc
switch using the spanner flats on the body. Avoid tightening the switch via the electrical en
damage the switch.
damage the switch.
Alignment of the switch is critical to correct operation. The switch should be in line with the
in the direction of flow.
Alignment of the switch is critical to correct operation. The switch should be in line with the
Alignment of the switch is critical to correct operation. The switch should be in line with the
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
in the direction of flow.
in the direction of flow.
terminals labelled "COMM" and "NO".
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
Remove the lid on the electrical enclosure and insert the wires into the cable entry. Connec
terminals labelled "COMM" and "NO".
terminals labelled "COMM" and "NO".
60