Davey EcoMatic COMM500 Instructions D'installation Et D'utilisation page 35

Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Una volta scelta la posizione idonea, praticare un foro di 32 mm di diametro nel tubo.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Collocare l'O-ring nella scanalatura della superficie interna della metà superiore della ganascia del tubo.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
Il flussostato non deve essere installato sul lato inferiore di tubi orizzontali. the pipe.
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
the pipe.
the pipe.
35