Davey EcoMatic COMM500 Instructions D'installation Et D'utilisation page 13

Fit the lid onto the electrical enclosure and secure via the screw. Disconnect the gas sensor from the cell.
Remove the brass connector from the white wire on the cell cable. Strip the white wire and attach to the brown
wire from the flow switch via the supplied crimp.
Fit the brass connector on the lead from the flow switch onto the gas sensor on the cell.
Fit the lid onto the electrical enclosure and secure via the screw.
Fit the lid onto the electrical enclosure and secure via the screw.
Fit the lid onto the electrical enclosure and secure via the screw.
Disconnect the gas sensor from the cell.
Disconnect the gas sensor from the cell.
Disconnect the gas sensor from the cell.
Remove the brass connector from the white wire on the cell cable. Strip the white wire and a
Remove the brass connector from the white wire on the cell cable. Strip the white wire and at
Remove the brass connector from the white wire on the cell cable. Strip the white wire and a
wire from the flow switch via the supplied crimp.
wire from the flow switch via the supplied crimp.
wire from the flow switch via the supplied crimp.
Fit the brass connector on the lead from the flow switch onto the gas sensor on the cell.
Fit the brass connector on the lead from the flow switch onto the gas sensor on the cell.
Fit the brass connector on the lead from the flow switch onto the gas sensor on the cell.
13