AirApp RH60 Notice D'utilisation page 11

Please read the operating instructions completely and observe all the information included for your own safety.
1. Technical data – Hydraulic jack RH60
Description
Max. load-bearing
capacity
Swivelling chassis
roller
Lifting height
Clearance to wheel
holder #1 min. / max.
Length of roller,
wheel holder #5
Vehicle wheel width
Hydraulic oil quantity
Weight
1 x hydraulic jack, main assembly
1 x locking pin with chain
4 x swivelling chassis rollers
1 x operating instructions, safety instructions, declaration of conformity, spare parts list
1. If possible, take the hydraulic jack out of the box with the aid of a second person.
2. The RH60 is completely assembled and ready for operation immediately.
3. The hook #6 is for holding down the foot pedal #2 during transport.
• The prescribed safety instructions are to be observed when using the hydraulic jack.
• Shut down the engine and apply the vehicle's handbrake.
• Remove the locking pin #3 from the hole.
• Then, open the vent valve #4 by turning it anti-clockwise (Attention! Never unscrew it or remove it completely!).
Push both rollers #5 of the wheel holder apart to position them under the wheel. Both rollers #5 must have con-
tact with the tyre on both sides.
• Close the vent valve #4 by turning it clockwise.
• Check that the hydraulic jack is aligned parallel to the wheel and has a clearance of about 20 mm to the rim
well. Any non-parallel alignment will generate transverse forces that are too high and that could destroy the
rollers #5, thus rendering the warranty invalid for the hydraulic jack.
• Operate the foot pedal #2 with short strokes at first to press the rollers #5 firmly against the tyre. Then, continue
to pump with full strokes, until the tyre lifts off the ground (max. 30 mm). (The closer the vehicle's wheel is to the
ground, the more steadily can the vehicle be moved using 4 hydraulic jacks.)
• Insert the locking pin #3 completely into the hole.
• Carry out the steps described above on all four wheels before the vehicle may be moved with the hydraulic
jacks.
• Before lowering the vehicle, check that no persons or limbs of persons are under the vehicle.
• Carefully remove the locking pin #3. (if it jams slightly, then press the foot pedal #2 to get the necessary play.)
• Then, open the locking pin #4 by turning it anti-clockwise (Attention! Never unscrew it or remove it completely!).
Push both rollers #5 of the wheel holder apart to release them from the tyre and pull the hydraulic jack forwards.
Carry out these steps at all four wheels before the vehicle stands on the ground again.
© Copyright – AirApp Power Tools GmbH • Siemensstrasse 9 – 11 • 40885 Ratingen • Germany
Store the manual at a safe place.
Figure 1
0.68 metric tons
Ø 100 mm
max. 30 mm
340 mm / 620 mm
300 mm
max. 310 mm
0.5 litres HLP ISO VG 32
18 kg
3. Scope of delivery of the hydraulic jack
Open the packaging and check the contents.
4. Assembling the hydraulic jack
5. Application of the hydraulic jack
2. Function of the hydraulic jack
A hydraulic jack is a lifting device that is used under the
•
wheels of a vehicle to raise the vehicle and then manoeuvre
it. After lifting the vehicle, the hydraulic jack must always be
secured with the locking pin #3. Only use the holes intended
for the locking pin.
Observe the safety instructions for the hydraulic jack.
•
9