Aritech DIGITALK 2000 Guide D'installation page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Mechanical alignment by using a periscope
Electro-optical alignment
Align the parabolic mirrors of the transmitters until the LED lights on the receiver panel light up. This
also applies to the LED lights of the radio controoled module, which is optional.
The alignment of both mirrors (top and bottom) must be carried out separately. However, the operating
module switch MO of the transmitter and receiver mirrors must be aligned at the same time. Note that
corresponding mirrors must be adjusted for both transmitter and receiver.
LED
7
6
5
4
3
2
1
Putting into operation
Adjustments at the transmitter
channel CH (➨9)
channel 1
1
2
O
N
channel 2
1
2
O
N
channel 3
1
2
O
N
channel 4
1
2
O
N
coding jumper
coding jumper
GND (➨3)
connecting clamp 2-GND is
connected with housing
Power (➨5)
transmission power high for
greater distances
Insert the periscope support into the top pair of mirrors of the
transmitter and, looking through the periscope, carefully
position the mirror so that you can see in its center the
corresponding mirror on the opposite pillar. Repeat for the
other mirrors of the transmitter and receiver. If there is a large
distance between the transmitter and receiver, use a
searchlight to improve.
receiver (alignment mode)
alarm (no IR-connection)
alignment signal
The more LEDs are lighting up the better
the distance has been adjusted
mode MO(➨8)
operating mode
operating mode
alignment upper parabolic mirror
alignment parabolic mirror below
jumper removed
connecting clamp 2- is not
connected with housing
transmission power low for
shorter distances< 40m/
80m)
- 15 -

Publicité

Table des Matières
loading

Table des Matières