Cherry DW 9000 SLIM Mode D'emploi page 13

64410032-00_DE-EN-FR-ES-IT-NL_DW9000Slim.fm Seite 13 Montag, 3. September 2018 8:03 08
Parallel login to multiple PCs /
laptops
Bluetooth automatically detects if a PC or
laptop that has already been connected to
the devices is switched on. In this case,
Bluetooth does not allow a new connection
with any other PC or laptop, thus preventing
inadvertent entries.
• Turn off the first PC/laptop or disable the
connections.
If your PC or laptop does not have Bluetooth, or
if you do not want to make any settings, you
can connect the devices to it via the wireless
receiver.
3.1 Connecting the devices via
Bluetooth
If the devices are already connected to another
PC or laptop, you cannot establish a parallel
connection. Turn off the first PC/laptop or
disable the connections.
1 Open the search for Bluetooth devices on
your PC or laptop (for example via Start >
Settings > Devices > Bluetooth).
2 Follow the software instructions.
3 Slide the switch on the back of the keyboard
or the bottom of the mouse to BT.
4 Activate the keyboard/mouse Bluetooth
connection by pressing the button next to
the BT switch.
The LED flashes blue.
If the LED does not flash blue:
• The keyboard/mouse is already connected
to another PC or laptop. Switch it off or
disable that connection.
5 Follow the software instructions.
The LED goes out and the device is
connected to your PC or laptop.
If the LED rapidly flashes red, the connection
has failed.
• Try again.
3.2 Connecting devices via the
receiver
The receiver is in the compartment on the
bottom of the mouse and is held by a magnet.
1 Pull the receiver out of the housing of the
mouse.
2 Connect the receiver to a USB port on the
PC or laptop.
3 Slide the switch on the back of the keyboard
or the bottom of the mouse to RF.
The LED on the mouse or the back of the
keyboard lights up red to confirm. The
keyboard/mouse is connected to your PC/
laptop.
EN
13