Maintenance - Faro SK07 Série Mode D'emploi

MAINTENANCE

Cleaning of hatch
Cleaning of hatch sealing
Cleaning of hatch
Porthole cleaning
Cleaning of camera and trays
Porthole gasket cleaning
Cleaning of hatch sealing
Cleaning of front door
Cleaning of camera and trays
Chamber and accessory cleaning
Cleaning of the filter of the camera
Cleaning of front door
Front panel cleaning
Adjustment of hatch
Chamber filter cleaning
Cleaning of the filter of the camera
Replacement of the batteriological filter
Adjustment of hatch
Porthole door adjustment
Replacement of the hatch gasket
Bacterial filter replacement
Replacement of the batteriological filter
Porthole gasket replacement
Replacement of the hatch gasket
Vacuum test EN 17665
Vacuum Test EN 17665
Bowie & Dick Test 17665
Bowie & Dick Test EN 17665
Vacuum test EN 17665
Helix Test EN 17665
Helix Test EN 17665
Bowie & Dick Test EN 17665
Safety Check (electrical) - EN 62353
Front panel cleaning
Helix Test EN 17665
- Safety earthing continuity
- Protective Hearth continuity
Safety Check (electrical) - EN 62353
- Insulation test
- Insulation test
- Protective Hearth continuity
- Enclosure leakage current
- Casing dispersion current
- Insulation test
- Enclosure leakage current
Initial validation EN 17665
Initial Validation EN 17665
Periodic validation EN 17665
Periodic Validation EN 17665
Initial Validation EN 17665
Safety valve check
Check of the safety valve
Periodic Validation EN 17665
Check of the safety valve
Before proceeding with the operations indicated below, always switch off the
main switch (1 Fig. 1) and check the chamber cools.
Use is forbidden of hydrochloric acid and detergents containing chlorine to clean any part
of the autoclave.
- Cleaning the sterilisation chamber and the accessories inside
Check: Monthly or every 50 cycles.
Use a soft cloth soaked in water so that the protective surface treatment of the chamber is
not damaged. Rinse with plenty of water and, at the end of the operation, dry. If necessary,
dampen the cloth with white vinegar to remove any limescale.
You are however advised to clean the chamber only if strictly necessary.
If limescale deposits are present, immediately check what is causing them. The formation of
white patches at the bottom of the chamber means poor quality water is being used or water
with incorrect characteristics compared to those required.
- Porthole cleaning
Check: Daily or every 5 cycles.
Use a soft cloth soaked in water to avoid damaging the protective treatment of the porthole.
54
MAINTENANCE OPERATIONS
MAINTENANCE OPERATIONS
Operation
Operation
Operations
PERIODICAL CONTROLS
PErIoDS CoNTroLS
PERIODICAL CONTROLS
Operation
Operations
Operation






Frequency
Daily Monthly
Frequency Frequency
5 cycles 50 cycles
Daily Monthly
Daily Monthly
X
5 cycles 50 cycles
5 cycles 50 cycles
X
X
X
X
X
X
X
X
X
Frequency
Frequency
Before
Before first Daily
Frequency
Daily
first use
Use
Before first Daily
X
Use
X
X
X
X
X
X
X




Quarterly Yearly
500 cycles 1000 cycles
Quarterly Yearly
Quarterly Annual
500 cycles 1000 cycles
500 cycles 1000 cycles
X
X
X
X
Yearly Every two 2 Years
Annually
years
Yearly 2 Years
X
X
X
X
X
X