SamplexPower Pure Sine Wave PST-600-12 Manuel Du Propriétaire page 39

SECTION 8 |
8.5.3 Providing Backup Power Using Transfer Switch
Switch will be able to switch both the Hot and the Neutral and will prevent tripping of
- Feed utility power and output power from the inverter to the two inputs of the Trans-
fer Relay
- Feed the output of the Transfer Switch to a Sub-Panel to feed AC loads requiring
- When Utility power is available, the 2 poles of the Transfer Switch will connect the
Hot and Neutral of the Utility power to the Hot and Neutral in the Sub-Panel. The
Supply Panel. As the Neutral of the inverter will be isolated from the Neutral of the
be connected to the Hot and Neutral of the Sub-Panel. As the Neutral is not bonded
8.6 GROUNDING TO EARTH OR TO OTHER DESIGNATED GROUND
vided for grounding the metal chassis of the inverter to the appropriate ground.
When using the inverter in a building, connect a 10 mm
against bare metal. Use star washers to penetrate paint and corrosion.
When using the inverter in a mobile RV, connect a 10 mm
stranded copper wire from the above equipment grounding lug to the appropriate
connections must be tight against bare metal. Use star washers to penetrate paint and
corrosion.
8.7 OPTIONAL WIRED REMOTE CONTROL
Installation
2
2
SAMLEX AMERICA INC. | 39
-
-