Section 8 Installation - SamplexPower Pure Sine Wave PST-600-12 Manuel Du Propriétaire

SECTION 8 | Installation
8.1 LOCATION OF INSTALLATION
Please ensure that the following requirements are met:
Working Environment: Indoor use.
Cool: Heat is the worst enemy of electronic equipment. Hence, please ensure that the
unit is installed in a cool area that is also protected against heating effects of direct
Well Ventilated: The unit is cooled by convection and by forced air-cooling by tempera-
ture controlled fan (behind openings 6, Fig 6.1). The fan draws cool air from air-suction
-
-
area with limited airflow. Keep a minimum clearance of 10" around the unit to provide
adequate ventilation. If installed in an enclosure, openings must be provided in the
Dry:
or fall on the unit.
Clean: The area should be free of dust and fumes. Ensure that there are no insects or
-
trical circuits inside the unit.
Protection Against Fire Hazard: The unit is not ignition protected and should not be
Closeness to the Battery Bank:
reduced efficiency. However, the unit should not be installed in the same compartment
are charged. The corrosive fumes will corrode and damage the unit and if the gases are
Accessibility:
Preventing Radio Frequency Interference (RFI): The unit uses high power switching
-
tronic equipment susceptible to radio frequency and electromagnetic interference as far
away from the inverter as possible. Read Section 3, "Limiting Electromagnetic Interfer-
ence (EMI)" for additional information.
SAMLEX AMERICA INC. | 29