Viking Range 5 Série Utilisation Et Entretien page 27

COLD WEATHER WARNING:
PROPANE
Extremely cold temperatures may cause your
ProSear™ burners to light inside the burners
instead of outside. Once lit, if you hear a
'whooshing' sound, immediately turn the burner
knobs off to extinguish the fl ame and then
immediately re-light the burners.
MANUAL LIGHTING
If a burner doesn't light after several attempts, it can be
match lit using the lighting rod stored in the drip tray.
Match-lighting your grill is done in one of three ways,
depending upon which burners are being lit.
First, make sure you've returned all of the control knobs
to the OFF position and have allowed 5 minutes for any
accumulated gas to dissipate before attempting to match
light a burner.
Manual Lighting Tube
Your grill features individual manual lighting tubes for all
main burners except for the right-most main burners.
Using the lighting rod, place a lit match in front of the
manual lighting tube for the burner you wish to light.
(See photo)
Push and turn the corresponding burner control knob to
"LITE". If the burner doesn't light within 5 seconds turn the
knob off and wait 5 minutes before attempting to light it
again. Once lit, gas will stop fl owing through the manual
lighting tube.
...continued
Right-Most Main Burner
The right-most main burner does not feature a manual
lighting tube.
To match-light this burner, use the lighting rod to insert a lit
match through the cooking grate into the front slot of the
briquette tray for that burner.
Push and turn the corresponding burner control knob to
"LITE". If the burner doesn't light within 5 seconds turn the
knob off and wait 5 minutes before attempting to light it
again.
ProSear™ Burner
The ProSear™ burner does not feature a manual lighting
tube.
To match-light this burner, use the lighting rod to insert
a lit match through the cooking grate and through the
protective screen.
Push and turn the corresponding burner control knob to
"LITE". If the burner doesn't light within 5 seconds turn the
knob off and wait 5 minutes before attempting to light it
again.
INSTALLATION / USE & CARE
|
27