JUKI HZL-G220 Manuel D'instructions page 33

3
Marking
Needle thread
4
Lever
5
Start from here
6
Stopper pin
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through the hole on the
presser foot and pull it out sideways.
Hole on the
presser foot
Place the fabric under the presser foot, align the marking with the
sewing-start point. Penetrate the needle into the fabric by turning the
hand wheel and lower the presser foot.
Sew-
ing-start
point
Lower the lever until it will go no further.
Lever should be backside of the projection of the presser foot.
Start sewing.
The machine will stop automatically after sewing the buttonhole.
* If a buttonhole of the same size will be sewn again, push the
thread trimming button to trim the threads and raise the press-
er foot.
Under this condition move to another point, lower the presser
foot and then start sewing.
* Do not change stitch length and/or zigzag width during button-
holing.
Otherwise this will cause imbalanced stitches.
* If thread trimming button is pushed while sewing buttonhole,
the machine will stop and will not complete the buttonhole. It
will start to sew from the beginning.
* Depending on material to be sewn and weaving direction of the ma-
terial, there might be a slight difference in zigzag widths between right
and left lines of buttonholes. Test sewing is recommended.
Opening the buttonhole using a ripper.
Ripper
[double bartack]
Pierce a stopper pin at the bartack and open the buttonhole with a
ripper.
Be careful not to cut the stitches.
[Keyhole buttonhole]
Eyelet punch Place a cardboard under the buttonhole and make a hole with the
eyelet punch.
Then pierce a stopper pin at the bartack and open the buttonhole with
a ripper.
* The icon on the screen will disappear
when the lever is correctly set.
31