Needle Thread Preparation; Threading The Needle Thread - JUKI HZL-G220 Manuel D'instructions

Needle thread preparation

Warning

Threading the needle thread

4
5
①
Lift the presser foot lifting lever.
②
Spool Cap
Spool Cap
Place a thread spool to the spool pin and a spool
cap onto the spool pin.
③
1
1
Thread to guide
16
Turn OFF the power switch before winding the bobbin thread.
2
1
3
6
Small spool
Large spool
.
* Align the marking
at the hand wheel
with the one on the
machine body.
2
Hold the thread end and thread according to the
arrow marking.
* Make sure that the presser foot is raised. Otherwise
the machine is not correctly threaded.
* Check that the thread take-up is correctly threaded.
3
④
6
Thread the guide
Note :
Make sure
to push
the needle
to the top.
It is impossible to perform stitch-
ing if the needle is not correctly
installed or a bent needle is used.
Pay close attention as this will
cause machine malfunction.
* Use the needle: No.11-16 and
the thread: No.30-90.
* When twin needle is used, the
automatic needle threader
can not be used.
4
5
6
from the right-hand side.