Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
, INSTRUCTIONS FOR CUTTING HAIR
•
For even cutting, allow the comb attachment/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the first time,
start with the maximum comb attachment.
, STEP 1 – Nape of the neck
•
Use 3mm or 6mm guide comb.
•
Hold the clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
•
Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head
•
With the 12mm comb attached, cut the hair at the back of the head.
, STEP 3 – Side of the head
•
With the 3mm or 6mm guide comb attached, trim sideburns. Then change
to the longer 9mm or 12mm guide comb and continue to cut up to the top
of the head.
, STEP 4 – Top of the head
•
With the 16mm or 18mm guide comb attached, cut hair on top of the head
against the diection in which it normally grows.
•
For longer hair on top, use without a guide comb. Lift the hair on top of the
head with a small hand comb. Cut over the hand comb with the hair lifted or
hold the hair between the fingers to lift it and cut it to the desired length.
•
Always work from the back of the head.
, STEP 5 – The finishing touches
•
Use the clipper without an attachment comb for close trimming around the
base and sides of the neck. Use the ear comb guides to get a clean line
around each ear. For the required ear comb guide, angle the clipper and
lightly stroke around each ear to the back of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper.
•
Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
, TAPER LEVER
•
The taper lever adjusts the length of cut when not using comb attachments.
•
It is suggested to set the blades closest together when using the comb
attachments. Half grade sizes can be achieved by using the taper lever with
comb attachments.
5
Publicité
Table des Matières
