Remington ColourCut Clipper HC5035 Mode D'emploi page 4

ENGLISH
F INSTRUCTIONS FOR USE
, BEFORE STARTING THE CUT
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
, TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Slide it onto and along the clipper blade until the front of the comb firmly sits
against the clipper and click into position.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, firmly push the
comb upward and away from the blades.
• Each comb attachment is marked accordingly on its outside middle surface.
, Please note a 0.5mm cutting length can be achieved from holding the
clipper, with no comb attachment, perpendicular to the skin. A 1.0mm
cutting length is achieved from holding the clipper, with no comb
attachment, with the top of the blade surface in contact with the skin.
• This is with the taper setting set at the closest gap between the blades.
Guide Combs
1 (Grade 0)
2 (Grade 1)
3 (Grade 2)
4 (Grade 3)
5 (Grade 4)
6 (Grade 5)
7
8
9
4
Cutting Length
1.5mm
3mm
6mm
9mm
12mm
16mm
18mm
22mm
25mm