Control Panel - Ayce B0012 Mode D'emploi

CONTROL PANEL

Sleeping
Dehumidifying
Timer
Stand-by button
Speed button
Timer button Mode button
Dehumidifying button
Sleep button
Low, middle high fan speed
Automatic, Cool, Fan mode
OPERATION
Turn on the unit
1. Plug in, then the unit beeps once.
2. Premi il tasto , ora l'unità è pronta.
3. The LED displays the room temperature and operates in Automatic mode.
SELECT OPERATING MODE
Press the button to select a desired mode shown below:
ADJUST TEMPERATURE
1. The temperature can be set within a range of 15°C to 31°C by 1°C
2. Press + or - button to increase or decrease the temperature 1°C by pressing once.
3. The unit LED shows the target temperature for 5 seconds and then displays the room
temperature.
ADJUST FAN SPEED
Press the button to select a desired fan speed shown below:
Speed Mode
Power
Timer/Temperature up button
Timer/Temperature down button
STANDBY
After pressing the button again, the unit will emit a "di" and stop working.
AUTOMATIC MODE
1. Once the Operation is selected, the indoor temperature sensor operates
automatically to select the desired operation mode with
2. When the room temperature 24°C ,the unit will automatically select
3. When the room temperature 24°C,the unit will automatically select
DEHUMIDIFY MODE
1. The up centrifugal fan will run at low speed, and the speed can't be adjusted.
2. The compressor and the down centrifugal fan will stop after running 8 mins, then run
again after 6 mins .
3. The unit adopts constant temperature dehumidifying mode ,and the adjustment of
temperature is no effective.
COOLING MODE
1. When the room temperature is higher than set temperature, the compressor starts to
run.
2. When the room temperature is lower than set temperature, the compressor stop and
upper fan operate at original set speed.
FAN MODE
1. The up centrifugal fan runs at set speed, and the compressor and down centrifugal fan
does not run.
2. The adjustment of temperature is no effective.
TIMER
1. Press "Timer" button to set Automatic Off time while the unit is running.
2. Press "Timer" button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hour. Press the temp
up + or - temp down button to increase or decrease the time 1 hour by pressing once.
74 | 75
GB
o
mode.
mode .