Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
1.
Install one 3V lithium CR 2025
(not included) battery, (see fi g. 1A).
2.
All the functions performed with the
remote control work identically to the
manual controls.
3.
When the remote control is not in use,
place it into the remote control storage
on the rear cover (See fi g. 1B).
Fig. 1B
OPERATION
The heater may be operated by the manual controls located on the heater
(as shown in fi g. 2) or by your remote control (shown in fi g. 1).
Fig. 2
1.
Place the heater on a fi rm, level surface.
2.
Plug the cord set into a fi t electrical outlet. Press the main power switch at the
back of the heater (power switch location see Fig. 3). When heater is on, the LED
panel will display the room temperature.
Fig. 1A
Fig. 1
Fig. 3
Turn on the heater by pressing the power button on the upper control panel.
The power is set at 1000 W.
Press the mode button once, the power goes up to 2000 W and all indications of the
power bars are lit.
Press the mode button twice to activate the AUTO mode radiator.
Press the mode button three times to switch into the fan mode (only the room
temperature is displayed).
Press the mode button four times to returns to 1000 W.
3.
To turn the heater off , press the power button again and turn off the power switch
(see fi g. 1 or 2 & 3).
REMARK: When switching the heater off , the fan of the heater will continue to work
around 30 seconds which helps to cool down the heater.
Setting the temperature (fi gure 2) :
1.
To set the temperature, press the "MODE" button two times, the heater turns into
"AUTO", and power indicator lines will fl ash 30 seconds. Press the TEMP. button to
(+) to increase the desired temperature and press TEMP. (-) to decrease the desired
temperature. When the correct temperature is set, the LED will be off after 30
seconds.
2.
When the air temperature reaches 2°C above the set temperature, the heater will
cut off automatically.
3.
When the air temperature drops 2°C below the set temperature, the unit will come
back on automatically.
4.
The selected temperature range is 16°C - 35°C.
Oscillation function:
This function will work in any mode. Pressing the OSC button will allow the heater to
oscillate side by side. To stop the oscillation, press the OSC button once more.
38 | 39
GB
Publicité
Table des Matières
