MSI MEG Z490 GODLIKE Mode D'emploi page 36

M.2 XPANDER-Z Gen4 S card LED Control
You can turn on/ off the LEDs by the switches.
M.2 EZ Access LED
M.2 Temperature LED
∙ FAN LED
▪ On (white) - It indicates that the fan is operating.
▪ Off - The fan is off.
∙ FAN LED switch - This switch is used to turn on/ off the FAN LED.
∙ M.2 LED switch - This switch is used to turn on/ off the M.2 EZ Access LED and M.2
Temperature LED.
∙ M.2 EZ Access LED - It indicate the status of M.2 SSDs.
▪ On (blue) - The installed M.2 SSDs were detected.
▪ Flash (purple) - The M.2 SSD is accessing data.
▪ Off - No M.2 SSD.
∙ M.2 Temperature LED - It indicates the temperature of M.2 SSD.
▪ Red - 65℃ and up
▪ Orange - 55 ~ 64℃
▪ Yellow - 45 ~ 54℃
▪ Green - 35 ~ 44℃
▪ Blue - 25 ~ 34℃
⚠
Important
This card can support up to PCIe 4.0 specification, but the actual transfer speeds are
dependent on the M.2 SSD, processor and chipset being used.
26
Overview of Components
FAN LED switch
M.2 LED switch FAN LED
+
+