Olympus CAMEDIA C-2020ZOOM Mode D'emploi page 9

Taking pictures
Press the Shutter release button halfway to lock the focus and exposure.
Press the Shutter release button fully to take the picture. When the Green
lamp stops blinking (after about 2 ~ 43 seconds), the camera is ready to take
the next picture.
Quick view
To switch to the Display mode, quickly press the LCD monitor ON/OFF button
twice in the Record mode. To return to the Record mode, press the LCD
monitor ON/OFF button or the Shutter release button.
Recording movies
Press the Shutter release button halfway to lock the focus and exposure. The
focus and exposure will be locked during the recording. Press the Shutter
release button fully to start recording. Press the Shutter release button fully
again to stop recording.
How to use the menu
Press the Menu button, then press the top/bottom arrows on the Jog dial to
select the item to adjust. Press the right arrow to display further selections.
Press the top/bottom arrows to adjust the item, and press the left arrow to
confirm the adjustment. Press the OK button.
Checking the batteries
When the power is turned on in the Record mode, the remaining battery
power will be displayed on the control panel.
lights and turns off automatically.
Batteries are OK. You can shoot.
blinks and other indicators on the control panel are displayed
normally.
Battery power is low and batteries should be replaced.
blinks and other indicators on the control panel go out.
Batteries are dead and should be replaced immediately.
Note:
• When the camera is being operated on batteries that are running low, the
camera may emit several short beeps and blink the number of storable
pictures on the control panel after you take a shot or when you turn on the
power. If this happens, the picture you have just taken will not turn out
properly. Replace the batteries and take the picture again.
9