Olympus CAMEDIA C-2020ZOOM Mode D'emploi page 23

Connecting to a personal computer
Use the appropriate connector according to your computer's platform.
IBM PC/AT compatible
Connect the provided RS-232C PC serial cable to the D-SUB 9-pin COM 1
or COM 2 serial port on your computer.
DOS/V
Apple Macintosh or compatible
Attach the provided conversion connector for Macintosh to the printer serial
port or modem serial port on your computer, and then connect the RS-232C
PC serial cable. (Turn off AppleTalk if connected to the printer port.)
The enclosed Macintosh conversion connector allows you to connect your
camera to a Macintosh computer. It cannot be used to connect a Macintosh
to a printer.
Macintosh
Conversion connector for Macintosh
Using apersonal computer
1. Make sure that the power of the personal computer and the camera are
OFF.
2. Connect the RS-232C PC serial cable to the computer's serial port.
3. Remove the lens cap, and connect the cable to the camera's Computer
connector.
4. Set the Mode dial on the camera to
5. Start CAMEDIA Master on the computer.
D-SUB 9-pin
serial port
Serial port
Computer connector
RS-232C PC serial cable
Computer connector
RS-232C PC serial cable
.
23